For the cases if your Passage Plan is not reflecting “Port Information” both in “Departure” / “Arrival” section, follow the steps below:

1. The reason is most likely the configuration around Port information searching area.

2. Do the following from the NavStation Configuration page:

a. Go to “Configure”.

b. Switch to “Passage planning”, its “Data collection”.

c. Adjust the “Port information picking range” in NM:

3. Close the configuration.

4. Switch back to your Passage Plan and check what you have in the “PORT INFORMATION” section of your Departure and         Arrival passage plan sections.

5. Most of the fields must be completed automatically: